HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 11 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM0x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Changing a local device address domain ID is not allowed.Changing a local Device
Address Domain ID is not
allowed.
YKM037E ISPF
The device number you specified was not found.Specified DEVN is not found.YKM038E ISPF
The device you specified is not a command device because the
APID cannot be used.
Specified device is not
command device because
APID is not available.
YKM039E ISPF
For the Cnt Ac-J Z copy group definition, you need to specify a
C/T group ID and a sub C/T group ID.
A Consistency Group ID (C/T
ID,sub C/T ID) is required for
CAJ Copy Group definition.
YKM040E ISPF
For the BC Z/Cnt Ac-S Z/TCA copy group definition, you cannot
specify a sub C/T group ID.
A sub Consistency Group ID
cannot be specified for BC
YKM041E ISPF
Z/CA/TCA Copy Group
definition.
This C/T group ID is already defined. Choose a different ID.This Consistency Group ID
(C/T ID,sub C/T ID) is
YKM042E ISPF
already defined. Choose a
different ID.
For the Cnt Ac-J Z copy group definition, you need to specify a
mirror ID.
A Mirror ID is required for
CAJ Copy Group definition.
YKM043E ISPF
This path set ID is already defined.This Path Set ID is already
defined.
YKM044E ISPF
The physical path is already defined as a logical path.Physical path (priport secport)
is already defined in this
logical path.
YKM045E ISPF
priport
The primary port you specified
secport
The secondary port you specified
The end CU/command control address value is lower than the
start CU/command control address value.
The end CU/CCA value must
not be lower than the start
CU/CCA.
YKM046E ISPF
A remote route entry cannot be added in the following cases:You cannot add a remote
route entry if the specified
YKM047E ISPF
• When the device address domain ID is the same as the local
device address domain ID or Non Gen'ed device address
domain ID.
DADID matches a local or
Non Gen'ed DADID or if a
scan has already been
• When the pair of the device address domain ID and storage
system has already been scanned.
performed for the
combination of the specified
DADID and storage system.
Devices cannot be scanned because in the Set Defaults panel,
the remote device address domain ID or Non Gen'ed device
You cannot perform a device
scan because in the Set
YKM048E ISPF
address domain ID has been specified as the local device address
domain ID.
Defaults panel, a remote DAD
ID or Non Gen'ed DAD ID
was specified as the local
DAD ID.
The storage system cannot be selected because it has not yet
been scanned.
This storage system can't be
selected because it hasn't
been scanned yet.
YKM049E ISPF
The specified copy group attribute value is invalid for this
command.
Invalid Copy Group attribute
name
YKM050E MSG
SC=36 RC=48
(attribute-value)
70 Messages