HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 27 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKX0x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
For details about the return code, see IKJCT441 in the
TSO/E Programming Services.
nnnn
Error code returned upon REXX
access
The command device definition for the storage system
identified by serial-number failed.
Storage system serial-number
Command Device Definition
Failed.
YKX065W MSG SC=4
RC=0
When the SN parameter is specified, processing
terminates normally. Without the SN parameter,
processing continues.
Operate according to the I/O error messages issued
simultaneously.
serial-number
Serial number of the corresponding
storage system.
The route list to be processed was not found.Necessary Route List is not found.YKX066E MSG SC=48
RC=48
Check the ROUTE parameter, DAD parameter, route list
definition file, and command device definition file
specified in the YKLOAD command. Check that the
information corresponding to the storage system serial
number specified in the YKBLDCMD command is set.
The YKBLDCMD command terminated with the return
code nnnn and the reason code rrrr.
YKBLDCMD command return
code=nnnn, reason code=rrrr
YKX099I TSO
This message is always displayed to indicate the return
code and the reason code.
nnnn
Maximum among the severity codes
returned during command execution
Table 28 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKX1x)
Explanation and Recommended ActionsMessage TextMessage ID
Invalid parameters are specified.Supplied parameters invalidYKX100T TSO RC=48
For details, see the reason code in the YKX199I
message that will appear after this message. For
reason codes, see IKJPARS in the TSO/E Programming
Services.
Nothing is assigned to the APID parameter.No application id APID() suppliedYKX101E MSG SC=48
Nothing is assigned to the CCA parameter.No command control address
CCA() supplied
YKX101E MSG SC=48
Nothing is assigned to the CU parameter.No control unit# CU() suppliedYKX101E MSG SC=48
Nothing is assigned to the DEVN parameter.No device# DEVN() suppliedYKX101E MSG SC=48
Nothing is assigned to the MSG parameter.No message MSG() suppliedYKX101E TSO RC=48
Nothing is assigned to the SN parameter.No serial# SN() suppliedYKX101E MSG SC=48
96 Messages