HP P9000 Snapshot User Guide (AV400-96394, October 2011)

Table 21 RAID Manager error codes for SSB1: B901, B9A8, B9A9, B9AD, B9AE (continued)
Cause of ErrorRAID Manager
Command
SSB2
Since quorum disks are specified as P-VOLs of Snapshot pairs, the command
ends abnormally.
paircreate, pairsplit,
pairresync, pairresync
-restore
9786
Since quorum disks are specified as S-VOLs of Snapshot pairs, the command
ends abnormally.
paircreate, pairsplit,
pairresync, pairresync
-restore
9787
Since one of the following cases occurred, the Snapshot pair cannot be created
by specifying the consistency number.
paircreate978a
• The specified consistency group number is in use for Business Copy.
• The number of pairs has already exceeded the maximum number of pairs
that can be created for one consistency group.
• The pair that uses the same P-VOL exists already in the specified consistency
group.
The Snapshot pair cannot be created because the specified consistency group
number is out of the range of the number that can be specified.
paircreate978b
The Snapshot data cannot be stored because the Continuous Access Synchronous
asynchronous pair status is other than PSUS or PSUE when Snapshot (P-VOL)
and Continuous Access Synchronous asynchronous (S-VOL) share the volume.
pairsplit978c
The Thin Provisioning virtual volume, which is undergoing capacity expansion,
is specified as the Snapshot P-VOL. Therefore, the Snapshot pair cannot be
created.
paircreate9790
The Snapshot pair cannot be created because the Thin Provisioning V-VOL that
is discarding zero data is specified as a P-VOL of the Snapshot pair.
paircreate9793
Since the volume without path definition is specified as a P-VOL of the Snapshot
pair, the command ends abnormally.
paircreate, pairsplit,
pairresync, pairresync
-restore
9796
Since the volume without path definition is specified as a S-VOL of the Snapshot
pair, the command ends abnormally.
paircreate, pairsplit,
pairresync, pairresync
-restore
9797
Already you made the maximum number of Snapshot pairs, no new Snapshot
pair can be created.
paircreate97A1
The Snapshot pair operation failed because the specified S-VOL is wrong.paircreate, pairsplit,
pairresync
B912
The consistency group information can not be obtained because the Snapshot
is not installed.
All commandsB9A7
52 Troubleshooting