HP XP P9000 for Business Continuity Manager Software User Guide (T5253-96081, July 2013)

Table 55 Required configuration files (3DC Multi-Target (Cnt Ac-J Z x Cnt Ac-J Z) configuration) (continued)
RemarksDescriptionItem
R-JNL number: Same value as the R-JNL number
between the primary site and remote site 2
Mirror ID: A non-zero value that is different from
the mirror ID of any other Primary → Remote 1
and Primary → Remote 2 Continuous Access
Journal Z copy pairs
--Prepare the following route lists by referring to
Table 56 (page 185):
Route list definition
file and command
device definition
file
• The route list that is required when all sites are
available
• Route list used when a failure occurs at a site
(recommended)
This item is not necessary if you use Remote Web
Console to set up logical paths.
A path set for inter-disk controller logical paths
(bidirectional) between the following sites is required:
Path set definition
file
• Primary site and remote site 1
• Primary site and remote site 2
• Remote site 1 and remote site 2
The following table describes the route list required for operation in a 3DC Multi-Target (Cnt Ac-J
Z x Cnt Ac-J Z) configuration.
Table 56 Required route list (3DC Multi-Target (Cnt Ac-J Z x Cnt Ac-J Z) configuration)
Required route listRemote site 2
state
Remote site 1
state
Primary site
state
Host on which Business
Continuity Manager is
started
Primary → Remote 1UsableUsableUsablePrimary host
Primary → Remote 2
Primary → Remote 1UnusableUsableUsable
Primary → Remote 2UsableUnusableUsable
Not requiredUnusableUnusableUsable
Remote 1 → PrimaryUsableUsableUsableRemote host 1
Remote 1 → Remote 2
Remote 1 → PrimaryUnusableUsableUsable
Remote 1 → Remote 2UsableUsableUnusable
Not requiredUnusableUsableUnusable
Remote 2 → PrimaryUsableUsableUsableRemote host 2
Remote 2 → Remote 1
Remote 2 → PrimaryUsableUnusableUsable
Remote 2 → Remote 1UsableUsableUnusable
Not requiredUsableUnusableUnusable
Legend:
Usable: The target site can be used.
Unusable: The target site cannot be used because of an error.
Defining a 3DC Multi-Target (Cnt Ac-J Z x Cnt Ac-J Z) configuration 185