HP XP P9000 RAID Manager Installation and Configuration User Guide (T1610-96046, August 2012)

Table 10 Supported platforms: IPv4 vs. IPv6 (continued)

RAID Manager / IPv6

IPv6

IPv4

N/AAVAVN/AAVAVAVTru64

AVAVAVN/AAVAVAVOpenVMS

N/AAVAVN/AAVAVAVIRIX64

N/AN/AN/AN/AN/AN/AN/ADYNIX

See “About platforms supporting IPv6” (page 18).

Legend

AV: Available for communicating with different platforms.

N/A: Not Applicable (Windows LH does not support IPv4 mapped IPv6).

Minimum platform versions for RAID Manager/IPv6 support:

• HP-UX: HP-UX 11.23 (PA/IA) or later

• Solaris: Solaris 8/Sparc or later, Solaris 10/x86/64 or later

• AIX: AIX 5.1 or later

• Windows: Windows 2008(LH), Windows 2003 + IPv6 Install

• Linux: Linux Kernel 2.4 (RH8.0) or later

• Tru64: Tru64 v5.1A or later. Note that v5.1A does not support the getaddrinfo() function, so this must be specified

by IP address directly.

• OpenVMS: OpenVMS 8.3 or later

Requirements and restrictions for z/Linux

In the following example, z/Linux defines the Open Volumes that are connected to FCP as /dev/sd*.

Also, the mainframe volumes (3390-xx) that are connected to FICON are defined as /dev/dasd*.

Figure 1 Example of a RAID Manager configuration on z/Linux

Requirements and restrictions for z/Linux 13