HP XP P9000 Smart Manager for Mainframe Messages (TB589-96003, July 2013)

Explanation and recommended actionsMessage textMessage ID
The YKENV command terminated.
return-code
Return code issued by the YKENV command
YKENV command return code=re-
turn-code.
YKZ371I TSO
Table 45 List of messages (message ID YKZ40x)
Explanation and recommended actionsMessage textMessage ID
The parameter indicated by param cannot be specified for a copy
group with a copy type of copy-type.
Check the copy type and the parameter.
param (string)
The parameter name which cannot be specified
copy-type (string)
The copy type specified for the copy group
param parameter cannot be spe-
cified for copy-type Copy Group.
YKZ400E MSG
SC=48 RC=48
The storage system which the command is issued onto, or the storage
system which uses the Remote DKC Control Function, does not support
the parameter indicated by param.
Use a device which supports the parameter indicated by param. Also,
if a scan has not been performed after the storage system microcode
was replaced, perform another scan.
param (string)
The parameter name which is not supported
Some of the storage systems do not
support param.
YKZ401E MSG
SC=48 RC=48
The copy pair entered an unexpected status while registering the journal
group to EXCTG.
Check that the status to be monitored is correctly specified. If the status
is correctly specified, execute the YKQUERY command to determine
the cause of the problem and rectify the error.
jj (hexadecimal number)
The journal group number specified by the consistency group ID
(00-FF)
kk (hexadecimal number)
The journal group number specified by the sub consistency group
ID (00-FF)
m (decimal number)
Mirror ID (0-3)
ssssssssssss (decimal number)
The storage system serial number
nnnn (string)
The status after the transition
Unexpected transition occurred while
adding JNLG to EXCTG. (CT ID=jj,
sub CT ID=kk, MIRROR=m,
SN=ssssssssssss, STATE=nnnn)
YKZ402E MSG
SC=44 RC=44
The target copy pair was not found.
Check the volume status, correct errors involved in the configuration
or execution conditions if any, and then re-execute the command.
If the YKMAKE SELECT(COND) command is issued on a copy group
container with EXCTG ID specified but without specifying the DEVN
parameter, the EXCTG registration I/O is issued even if this message
is output.
No pair processed in Copy
Group(s).
YKZ403I MSG SC=0
RC=0
Messages 195