Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

16. Shut down the host.
Leave the host in a single-path configuration until you check (in step 24)
whether HDLM has been successfully installed.
17. On all the hosts that make up the cluster system, perform steps 3 to 16.
18. Make sure that all the hosts that make up the cluster system have been
completely shut down.
19. Restart each host.
20. Log on to Windows again as a member of the Administrators group.
21. Make sure that the program is running properly, by examining the results
of the dlnkmgr command's view operation.
An example of executing the dlnkmgr command's view operation is as
follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
22. Use the results of the dlnkmgr command's view operation to check the
version of the installed HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
23. Use the results of the dlnkmgr command's view operation to check that
the programs are running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
24. After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-69, and make sure that you
have successfully installed HDLM in a single-path configuration.
3-50
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Windows
®