Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

Figure 3-5 Hitachi Network Objectplaza Trace Utility 2 Release 2.0
Dialog Box.
2. In Number of Files, change the number of integrated trace files.
The default is 4. You can specify a value from 1 to 16.
The value you specify here will apply to n in program-installation-
destination-drive:\Program Files\HITACHI\HNTRLib2\spool
\Hntr2n.log (n indicates a file number).
3. In File Size(KB), change the size of an integrated trace file.
The default is 256 (kilobytes). You can specify a value from 8 to 8192.
Specify a value greater than or equal to the setting of Buffer Size(KB).
4. In Buffer Size(KB), change the buffer size.
Change the buffer size for the monitoring cycle.
The default is 64 (kilobytes). You can specify a value from 8 to 2048.
Specify a value smaller than or equal to the setting of File Size(KB).
5. In Interval Timer(Sec), enter a value to shorten the monitoring cycle.
The default is 10 (seconds). You can specify a value from 1 to 300.
6. In Lookout Span(Sec), enter a value to specify the interval for
monitoring the number of messages to be output to the integrated trace
file.
The default is 0 (seconds). You can specify a value from 0 to 3600.
If you specify 0, you cannot adjust the number of messages to be output
because the system ignores the setting of Max Messages / Span.
7. In Max Messages / Span, enter a value to specify the maximum
number of messages to be output to the integrated trace file at the
monitoring interval specified in Lookout Span(Sec).
Creating an HDLM Environment
3-83
Hitachi Dynamic Link Manager User Guide for Windows
®