Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

When you create a partition, assign the same drive letter as the one
assigned for node A in step 3.
6. Stop node B, and then restart node A.
7. On node A, register the new LU in MSCS, and set it up.
8. Restart node B.
Checking an Added Path
You can add a path, by inserting a cable into an existing LU, even while the
host (on which HDLM is installed) is running.
When you add a path without adding an LU, what is displayed in the disk
management window does not changed.
You can confirm that a path has been added by using the HDLM command
view operation, or the HDLM GUI. The figure below shows an example of how
to use the command to confirm that a path has been added. For an example
of how to use the HDLM GUI to confirm that a path has been added, see the
HDLM GUI Help.
Figure 4-2 Using the command to confirm that a path has been added
Note:
¢
The PathID is determined by the system choosing the smallest,
available number that is not already in use for another path. For
example, when a path is deleted, and then a new path is added, the
PathID for the added path might not be the same number as the
deleted PathID.
¢
When a path not recognized by Windows is added to an LU for the
first time, the following messages might appear:
- KAPL08019-E and KAPL08022-E
4-18
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Windows
®