Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

dlnkmgr online [-path] -cha -pathid AutoPATH_ID [-s]
dlnkmgr online [-path] [-pathid AutoPATH_ID] [-s]
dlnkmgr online [-path] [-hbaportwwn HBA_Port_WWN
[-tid Target_ID -hlun Host_LUN]] [-s]
dlnkmgr online [-path] -hapath [-lu -pathid AutoPATH_ID]
[-s]
dlnkmgr online [-path] -dfha [-lu -pathid AutoPATH_ID] [-
s]
Valid value
AutoPATH_ID { 000000 - 999999 }(Decimal)
Host_LUN { 0000 - FFFF }(Hexadecimal)
KAPL01001-I The HDLM command completed normally. Operation
name = online, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Reference
Using the view operation together with Windows commands enables you to
filter the path information listed for a specific HBA port or channel adapter
port. For details about the view operation, see
view (Displays Information) on
page 6-32.
We recommend that you use the following command and verify the
information on the target paths before you execute the online operation to
place online all the paths connected to a specific HBA port or channel adapter
port.
Example 1
The following example shows how to filter and display the information on
all paths that pass through the HBA port whose host port number is 0004
and bus number is 0001:
dlnkmgr view -path | find "0004.0001"
The above command will display information on all the paths that pass
through the specified HBA port.
Example 2
The following example shows how to filter and display the information on
all paths that pass through the channel adapter port 0A of the Thunder
9500V Series:
dlnkmgr view -path -stname | find "9500V" | find "0A"
The above command will display information pertaining to only those
paths that pass through the specified channel adapter port.
Note:
When the LU dynamic deletion function is used, a path might be deleted due
to an error. If this happens and you attempt to change the path status, an
error will occur. Confirm that the path, which you attempt to change the
Command Reference
6-15
Hitachi Dynamic Link Manager User Guide for Windows
®