Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

The following example shows how to update the license key when the
license key file does not exist:
PROMPT>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01083-I There is no license key file. File name =Windows-
installation-destination-drive-name\hdlm_license
KAPL01068-I Enter a license key:*************
KAPL01071-I A permanent license was installed.
PROMPT>
-rmlu { on [ -force ] | off }
Enables or disables the LU dynamic deletion function.
on: Enabled
off: Disabled
The default is off.
The following sub-parameter can be used to specify how the LU dynamic
deletion function operates.
-force
The LU is removed from under HDLM-management when all the paths
to the LU are disconnected, even when an Offline(C) path is
included in the paths connected to the LU.
For details on the LU dynamic deletion function, see Deleting an LU
Dynamically on page 4-19. The following table shows the values and
descriptions of the LU dynamic deletion function.
Table 6-7 Values for the LU Dynamic Deletion Function
Value Description
off
The LU will not be removed from under HDLM-management, even if an
error occurs on all the paths to the LU, all the paths to the LU are
disconnected, or the LU is deleted. The path statuses are Offline(E)
and Online(E). This operation is the same as the in HDLM 05-01 or
earlier. The off option is recommended when you want to use the
same function as you used before in HDLM 05-01 or earlier, without
using the LU dynamic deletion function.
on
The LU is removed from HDLM-management when all the paths to the
LU are disconnected. However, if an Offline(C) path is among the
disconnected paths, the LU will not be deleted from HDLM-
management.
The deleted LU is restored after it is recovered from the physical failure
and the disk is re-scanned.
on -force
The LU is removed from HDLM-management when all the paths to the
LU are disconnected, even when an Offline(C) path is included.
The removed LU is restored after it is recovered from the physical
failure and the disk is re-scanned.
6-28
Command Reference
Hitachi Dynamic Link Manager User Guide for Windows
®