Hitachi Dynamic Link Manager Software Users Guide for Windows (7.6)

Requirements for Outputting Audit Log Data
HDLM can output audit log data when all of the following conditions are
satisfied:
• The Event Log service is running.
• The output of audit log data has been enabled by using the HDLM
command's set operation.
However, audit log data might still be output regardless of the above
conditions if, for example, an HDLM utility is executed from external media.
#
#:
The following audit log data is output:
¢
Categories: StartStop, Authentication, and ConfigurationAccess
¢
Severity: 6 (Error, Warning, or Information)
Note:
¢
You might need to perform operations such as changing the log size
and backing up and saving collected log data, because the amount of
audit log data might be quite large.
Destination and Filtering of Audit Log Data
Audit log data is output to event logs.
You can also filter the audit log output by specifying a severity level and type
for the HDLM command's set operation.
Filtering by severity:
The following table lists the severity levels that can be specified.
Table 2-11 Severity Levels That Can Be Specified
Severity Audit log data to output
Correspondence with event
log type
0 Error Error
1
2
3
4 Error and Warning Warning
5
6 Error, Warning, and Information Information
7
Filtering by category:
The following categories can be specified:
HDLM Functions
2-43
Hitachi Dynamic Link Manager User Guide for Windows
®