HP StorageWorks Disk Array XP1024: Site Preparation Guide (A7906-96013, July 2005)

52 HP StorageWorks Disk Array XP1024: Site Preparation Guide
electromagnetic
interference
The disk array is specifically designed to reduce its
susceptibility to radiated and conducted interference.
Electromagnetic interference can cause a variety of
system problems. Your HP CE can advise you about
many of the most common causes of electromagnetic
interference.
metal If metal is used in the construction of the raised floor,
ensure that there is a common ground connection
between the raised floor and main floor to avoid
possible build up of different voltage potentials.
Failure to comply can result in serious injury to
personnel and damage to equipment.
flammable
materials
Fundamental safeguards for disk arrays should include
a site well away from any sources of potential damage.
The system should not be installed or operated in an
environment where there is a risk of fire or explosion
due to the presence of highly flammable gases, volatile
liquids, or combustible dust.
airborne
contaminants
Airborne contaminants and particles of a certain size
and hardness can damage your disk arrays. Some of
the most common contaminants are dust, smoke, ash,
eraser debris, food crumbs, and salty air.
Your HP CE can assist you in determining whether or
not you need be concerned about airborne
contaminants.
Also, see Dust and Pollution Control (page 70) and
Metallic Particulate Contamination (page 70).