HP StorageWorks Disk Array XP operating system configuration guide for Tru64 UNIX XP24000, XP12000, XP10000, v01 (A5951-96066, June 2007)

Table 3 Host group mode (option)

CommentsDefaultFunction

Host

Group

Mode

Previously MODE272InactiveEnable use of XP Continuous Access Software

on Tru64 TruClusters.

CAUTION:

Changing host group modes for ports where servers are already installed and configured breaks all LUN

paths and will require the paths to be redefined. See “Defining the paths” on page 20.

Setting the System Option Modes

The HP service representative sets the System Option Mode(s) based on the operating system and

software configuration of the host.

Configuring the Fibre Channel ports

Configure the disk array Fibre Channel ports by using Remote Web Console (shown), or XP Command

View. Select the settings for each port based on your storage area network topology. Use switch

zoning if you connect different types of hosts to the array through the same switch. For detailed

procedures, refer to HP StorageWorks XP LUN Manager User's Guide available at:

http://www.hp.com/support/manuals.

Fibre address

In fabric environments, the port addresses are assigned automatically.

Installing and configuring Tru64 for the XP disk array16