HP StorageWorks XP24000 SNMP Agent Reference Guide, v01 (AE131-96006, June 2007)

• Set: Adds new IP addresses to the IP Address list b ox.

• Community & Trap allows you to add, delete, or change SNMP trap information. The registered

address is the trap destination for the speciﬁed community.

• Each com munity can have more than one deﬁned IP ad -

dress (sees “Adding a Community Name” on page 19 and

“Adding Community IP Addresses” on page 2 1).

• You can register up to 32 community nam es and up to 32 IP addresses per community name.

• You can use up to 180 alphanumeric characters for a community name. You cannot use the

following: ", \, ;, :, ,, *, ?, < , >, |, /, ^, &, %, andaspacebeforeorafter thecommunity

name.

• System Group allows you to add, delete or change SNMP system group i nformation. If system

group information has already been registered, the registered information displays. To register the

system group i nformation, the Extension SNMP check box must be selected. When you register

system group information, select Apply. S ystem group information is as follows:

• Name: Connected subsystem device name. Remote Web Console users can change the

device name. You can use up to 180 alphanumeric characters for a device name. You cannot

use the following: ", \, ;, :, ,, * , ?, <, >, |, /, ^, &, %, . You can use a space in the m iddle of

the

device name, but not b efore and after and a space before or after the device name.

Note:

Thedevicename isrequiredtouse SNMP Agent. Make sure to document thedevice

name, because settings will be cleared when SVP is replaced.

• Contact: Contact information such as personnel and telephone numbers where you c an

inquire about the connected subsystem. Remote Web Console users can change contact

information in Modify mode. Enter contact information using up to 180 alphanumeric

characters (ASCII codes), except for some symbols, such as ", \, ;, :, ,, *, ?, <, >, |, /, ^, &,

and %. You can also use a space, except before and after contact information.

Note:

Acontact name is required to useSNMPAgent. Makesuretodocument the contact

name, because settings will be cleared when SVP is replaced.

• Location: Location of connected subsystem. Remote Web Console users can change

device locations with the modify mode. You must enter a device location using up to 180

alphanumeric characters (ASCII codes). You can use a space, except for before and after the

location. You canno t use some symbols, s uch as ", \, ; , :, ,, *, ?, <, >, |, /, ^, &,and %.

Note:

The device location is required to use SNMP Agent. Make sure to document the device

location, because the settings will be cleared when SVP is replaced.

• Apply implements set tings made on this window.

• Cancel cancels settings made on this window.

Using

the SNMP GUI