Hitachi Dynamic Link Manager Software Users Guide for Linux

Upgrade Installation in an Environment Where an HDLM Device or a logical
volume (LVM2) on a HDLM device Is Used as a Boot Disk
To perform an upgrade installation of HDLM in a boot disk environment that
uses a HDLM device or a logical volume (LVM2) on a HDLM device (for
details, see
Upgrade installation of HDLM in a Boot Disk Environment on page
3-151):
1. Check the current HDLM settings.
See steps 2 to 5 in
Upgrade installation of HDLM in a Boot Disk
Environment on page 3-151.
2. Perform an upgrade installation of HDLM.
See step 6 to 9 in Upgrade installation of HDLM in a Boot Disk
Environment on page 3-151.
After completing the above procedure, you can perform an upgrade
installation of HDLM in a boot disk environment that uses a HDLM device or a
logical volume (LVM2) on a HDLM device.
Settings for a Multipath Boot Disk Environment
This subsection describes how to perform a new installation of HDLM in a
single-path boot disk environment that uses a SCSI device and how to
configure a multipath boot disk environment.
Note that if the settings are incorrect, the OS might not start. For details
about what action to take if the OS cannot be started from an HDLM device,
see
Countermeasures for Unsuccessful Startup of the OS from an HDLM
Device on page 3-155.
The name of the boot loader configuration file used in these procedures
differs depending on the boot loader and OS. The following table lists the
names of the boot loader configuration files.
Table 3-67 Names of Boot Loader Configuration Files
Boot loader Configuration file name
GRUB For Red Hat Enterprise Linux
/etc/grub.conf
For SUSE LINUX Enterprise Server
/boot/grub/menu.lst
ELILO
/etc/elilo.conf
To install HDLM in a boot disk environment that uses a SCSI device,
and set up the environment:
1. Log in to Linux as a user with root permissions.
2. If the OS is SUSE LINUX Enterprise Server 10 SP3 or later, specify
multipath=off in the boot loader configuration file.
If multipath=off is not specified in the kernel line of the boot loader
configuration file, specify multipath=off and then restart the server. The
following example shows how to specify multipath=off:
3-142
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Linux®) User Guide