Creating RAID arrays in the EFI shell - White Paper

711747-001 6

CONSTCHK - Start Consistency Check operation on the specified IR

Volume

ACTIVATE - Activate an Inactive IR volume

LOCATE - Locate a disk drive on an enclosure

LOGIR - Upload or Clear IR Log data

BOOTIR - Select an IR Boot Volume as primary boot device

BOOTENCL - Select an Enclosure/Bay as primary boot device

HELP - Display help information

where <parameters> are:

Command specific values; enter "sas2ircu <controller #> <command>"

to get command specific help

SAS2IRCU: Reconnecting the EFI Driver. Please wait...

Shell>

Example 2 – LIST the adapters to get the adapter number that will be used in other commands:

Shell> sas2ircu list

Results in:

LSI Corporation SAS2 IR Configuration Utility.

Version 14.00.00.00 (2012.07.04)

SAS2IRCU: Disconnecting the EFI Driver.

Adapter Vendor Device SubSys SubSys

Index Type ID ID Pci Address Ven ID Dev ID

----- ------------ ------ ------ ----------------- ------ ------

0 SAS2308_1 1000h 86h 00h:02h:00h:00h 103Ch 158Bh

SAS2IRCU: Utility Completed Successfully.

SAS2IRCU: Reconnecting the EFI Driver. Please wait...

Shell>

Example 3 – DISPLAY physical device information that will be used to create the arrays:

Shell> sas2ircu 0 display

Where the controller # “0” is the Index resulting from the LIST command.

Results in:

LSI Corporation SAS2 IR Configuration Utility.

Version 14.00.00.00 (2012.07.04)

SAS2IRCU: Disconnecting the EFI Driver.

Read configuration has been initiated for controller 0