HP SATA/SAS hard drive and Solid State Drive installation

Computers that use guide screws installed in the hard drive
NOTE: In some computers, such as the HP Z200 SFF or HP Z210 SFF Workstations, you may need to
temporarily remove the optical drive to install the hard drive. See the service guide for your workstation
at
http://www.hp.com/support/manuals.
1. If a card support interferes with access to the system board connectors, remove it.
2. Install four guide screws into the holes near the corners on the sides of the hard drive.
NOTE: Spare guide screws designated for this purpose may be found installed in the sheet
metal of the drive bay structure, or behind the front bezel.
●
Some computers, such as the HP Z200, HP Z210 CMT, and HP Z400 series Workstations,
use four vibration isolation guide screws (screws with blue grommets).
●
Some computers, such as the HP Z200 SFF, HP Z210 SFF, and HP xw4000 series
Workstations, use four 6-32 screws.
Figure 4 Installing the guide screws
3. Slide the hard drive into the selected bay until it snaps into place.
4. Continue with
Step 3—Connecting the power and data cables on page 9.
8 HP SATA/SAS hard drive and Solid State Drive installation