HP Workstations - Internal USB port kit installation

ManualsBrandsHP ManualsDesktopHP Z800 Workstation

Internal USB port kit installation

Introduction

The internal USB port kit provides a Type A female USB port compatible with Type A USB devices

internal to the computer chassis. This document describes how to install the internal USB port kit on

HP Z and xw series Workstations.

Kit contents

●

Internal USB port kit

●

Adjustable cable strap

● Warranty information

●

Internal USB port kit installation instructions (this document)

Before you begin

To view QuickSpecs and determine the compatibility of this product with your HP computer, see

http://www.hp.com/go/productbulletin.

ENWW Introduction 1

Summary of content (6 pages)

PAGE 1
Internal USB port kit installation Introduction The internal USB port kit provides a Type A female USB port compatible with Type A USB devices internal to the computer chassis. This document describes how to install the internal USB port kit on HP Z and xw series Workstations.
PAGE 2
Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of injury from a hot component, enable the surface to cool before touching. WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard.
PAGE 3
Step 1—Preparing for component installation NOTE: Computer models vary. All illustrations are examples only. Accessing the internal components of the computer 1. If you need help preparing the computer for this installation, consult the removal and replacement procedures in the service guide for your computer at http://www.hp.com/support/ manuals. 2. Power down the computer, and then disconnect the power cord. 3. Power down all external devices, and then disconnect them from the computer. 4.
PAGE 4
Step 3—Installing the internal USB cable Complete the following steps to install the internal USB cable, shown in the following figure. Figure 1 Internal USB cable 1. Attach the internal USB cable 1x5-pin receptacle ( A in the preceding figure) to the mating exposed pins of the available 1x5- or 2x5-pin header connector (which ever is available) on the system board: 1x5-pin header.
PAGE 5
2. Attach a USB key or other USB device to the Type A receptacle on the other end of the internal USB cable. NOTE: Although the internal USB cable is intended for use with a USB Key, it can be used with any USB device that has a compatible USB Type A male connector. 3. Using the adjustable strap with adhesive pad provided in the installation kit, affix the connected USB key or device to the computer chassis, as desired.
PAGE 6
Step 4—Reassembling the computer 1. Reinstall the card support, if applicable. 2. Reinstall the side access panel. 3. Reconnect external devices and power cord. 4. Restore power to the computer and all external devices. Japanese 日本語 This document is available in Japanese. See http://www.hp.com/support/manuals, then select your product and select Japanese from the drop down Manual Language menu. このドキュメントは日本語版が用意されています。http://www.hp.