HP xw and Z Workstations - Installing an HP Solenoid Lock and Hood Sensor

ManualsBrandsHP ManualsDesktopHP Z800 Workstation

Installing an HP Solenoid Lock and Hood

Sensor

Introduction

The side access panel Solenoid Lock is designed to prevent unauthorized removal of the computer

cover. The side access panel may be locked by using a local or remote signal-controlled solenoid.

The Hood Sensor is designed to notify the user of any removal of the computer cover.

Kit contents

● Solenoid Lock assembly, including solenoid, bracket, and cable

● Two tamper-resistant screws

●

Solenoid Lock FailSafe Key

●

Sensor and power cable

● Sensor bracket

●

Two sensor bracket screws

●

Warranty information

●

This installation guide

Before you begin

To determine the compatibility of this product with your HP computer, see QuickSpecs online at

http://www.hp.com/go/productbulletin.

Installing the Solenoid Lock and Hood Sensor in HP Workstations

Installations in HP Workstations, such as the HP Z600 Workstation series, may be different.

Complete installation and removal procedures for this product are included in the service guide for

your workstation model, available at

http://www.hp.com/support/manuals.

ENWW Introduction 1

Summary of content (6 pages)

PAGE 1
Installing an HP Solenoid Lock and Hood Sensor Introduction The side access panel Solenoid Lock is designed to prevent unauthorized removal of the computer cover. The side access panel may be locked by using a local or remote signal-controlled solenoid. The Hood Sensor is designed to notify the user of any removal of the computer cover.
PAGE 2
Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of injury from a hot component, enable the surface to cool before touching. WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard.
PAGE 3
Installing the Hood Sensor NOTE: Computer models vary, and all illustrations are examples only. For product-specific information, see the service guide for your HP computer at http://www.hp.com/support/manuals before beginning installation. The attachment point for the Hood Sensor may be located on the front panel, back panel, or sheet metal of the computer chassis, the plastic fan-duct housing, or the expansion card guide. 1.
PAGE 4
The attachment point for the Solenoid Lock may be located on the back panel or the top panel of the computer chassis. 1. Ensure that the security pin in the Solenoid Lock assembly is in the OFF position, as illustrated. If the pin is up, push it down to the OFF position. Figure 2 Security pin in the OFF position 2. Install the new lock assembly (1) on the inside of the rear panel or top panel of the computer using the two tamper-resistant screws (2) and the FailSafe Key included in this kit.
PAGE 5
Reassembling the computer 1. Replace the side access panel. 2. Reconnect the power cord to the computer and plug the power cord into a power outlet. Activating the Solenoid Lock NOTE: The Hood Sensor does not require activation. It is recognized and activated automatically by the computer. 1. Turn on or restart the computer. 2. Repeatedly press and release the F10 key until the Computer Setup Utilities menu appears.
PAGE 6
Disabling and removing the Solenoid Lock There are two methods to disable the Solenoid Lock. ● If you can access the F10 Setup utility, follow the steps in Disabling the Solenoid Lock via the F10 Setup Utility on page 6. ● If a Solenoid Lock is installed but you cannot access the F10 utility, follow the steps in Disabling the Solenoid Lock mechanically on page 6. Disabling the Solenoid Lock via the F10 Setup Utility 1. Turn on or restart the computer. 2.