Intel vPro Processor Technology Setup and Configuration for the HP Z1, Z210, Z420, Z620 and Z820 Workstations

27
f. Select TLS PSK. The Intel TLS PSK Configuration Screen appears
(Figure 27).
Figure 27. Intel TLS PSK Configuration Screen
i. Select Set PID and PPS.
Default setting: (None)
Recommended setting: (System dependent)
This option is for Provisioning ID (PID) and Provisioning Passphrase
(PPS) entry. PIDs are 8 characters and PPS are 32 characters. There
are dashes between every set of four characters so counting dashes
PIDs are 9 characters and PPS are 40 characters. They must be
generated by an SCS.
The Admin Password, PID, and PPS can be pre-populated by HP during
manufacturing. Refer to the OEM TLS-PSK section for more
information.
ii. Skip Delete PID and PPS. This function deletes the current PID and PPS
entries in the system.
iii. Select Previous Menu.
g. Skip TLS PKI.
h. Select Previous Menu.
18. Select Previous Menu to return to the MEBx Main Menu.
19. Select Exit to exit the MEBx Setup and save settings).
20. The system will display an Intel ME Configuration Complete message (only
once).
21. System will reboot.
22. Turn off system and remove power. At this point the system is out of Factory
Mode and is in In-Setup mode. It is ready to be deployed in a corporation.