Owner's Manual
Table Of Contents
- Get started
- Load media and paper basics
- Connect your printer
- Printer management tools
- Web Services
- Copy and scan
- Fax
- Send a fax
- Receive a fax
- Set up phone book contacts
- Change fax settings
- Fax and digital phone services
- Fax on Voice over Internet Protocol
- Use reports
- Additional fax setup
- Set up faxing (parallel phone systems)
- Select the correct fax setup for your home or office
- Case A: Separate fax line (no voice calls received)
- Case B: Set up the printer with DSL
- Case C: Set up the printer with a PBX phone system or an ISDN line
- Case D: Fax with a distinctive ring service on the same line
- Case E: Shared voice/fax line
- Case F: Shared voice/fax line with voice mail
- Case G: Fax line shared with computer modem (no voice calls received)
- Case H: Shared voice/fax line with computer modem
- Case I: Shared voice/fax line with answering machine
- Case J: Shared voice/fax line with computer modem and answering machine
- Case K: Shared voice/fax line with computer dial-up modem and voice mail
- Test fax setup
- Set up faxing (parallel phone systems)
- Manage cartridges
- Solve a problem
- Get help from the HP Smart app
- Get help from the printer control panel
- Get help in this guide
- Understand printer reports
- Solve Web Services problems
- Maintain the printer
- Restore original factory defaults and settings
- HP support
- HP EcoSolutions (HP and the Environment)
- Technical information
- Specifications
- Regulatory notices
- Regulatory Model Number
- FCC statement
- Notice to users in Korea
- VCCI (Class B) compliance statement for users in Japan
- Power cord instructions
- Notice to users in Japan about the power cord
- Noise emission statement for Germany
- European Union and United Kingdom Regulatory Notice
- Products with wireless functionality
- Visual display workplaces statement for Germany
- Notice to users of the U.S. telephone network: FCC requirements
- Notice to users of the Canadian telephone network
- Notice to users of the German telephone network
- Australia wired fax statement
- Regulatory information for wireless products
- Environmental product stewardship program
- HP tips for reducing environmental impact
- Eco-Tips
- Paper
- Plastics
- European Union Commission Regulation 1275/2008
- Safety data sheets
- Chemical substances
- EPEAT
- SEPA Ecolabel User Information (China)
- Recycling program
- HP inkjet supplies recycling program
- Battery disposal in Taiwan
- California Perchlorate Material Notice
- European Union Battery Directive
- Battery notice for Brazil
- Power consumption
- China Energy Label for Printer, Fax and Copier
- Disposal of waste equipment by users
- Waste disposal for Brazil
- The Table of Hazardous Substances/Elements and their Content (China)
- Regulation on the Control of Waste Electrical and Electronic Equipment (Turkey)
- Restriction of hazardous substance (India)
- Declaration of the Presence Condition of the Restricted Substances Marking (Taiwan)
- Index
The "Phone Cord Connected to Correct Port on Fax" test failed
If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord connector that plugs
into a telephone wall jack.) Try removing the splitter and connecting the printer directly to the telephone wall
jack.
Plug the phone cord into the correct port
1. Connect one end of the phone cord to your telephone wall jack, then connect the other end to the port
labeled on the back of the printer.
NOTE: If you use the port labeled to connect to the telephone wall jack, you cannot send or receive
faxes. The port labeled should only be used to connect other equipment, such as an answering
machine.
Figure 10-1 Back view of the printer
1 Telephone wall jack.
2
Use a minimum 26 AWG phone cord to connect to the port on the printer.
2. After you have connected the phone cord to the port labeled , run the fax test again to make sure it
passes and the printer is ready for faxing.
3. Try to send or receive a test fax.
152 Chapter 10 Solve a problem ENWW