Command Reference Guide

ManualsBrandsHP ManualsNetworkingHSR6800

About the HP HSR6800 Command References

The HP HSR6800 command references are part of the HP HSR6800 Routers documentation set. They

describe the commands and command syntax options available for the HP HSR6800 Routers. The HP

HSR6800 documentation set includes 12 command references:

Command

eference Content

Fundamentals Command

Reference

Covers the commands for logging in to and setting up an HSR6800 Router.

This command reference includes:

• CLI

• Logging In to the Router

• FTP and TFTP

• File Management

• Configuration File Management

• Software Upgrade

• Device Management

Interface Command Reference

Covers the interface configuration commands. This command reference

includes:

• Ethernet Interface

• ATM Interface

• WAN Interface

• POS Interface

• CPOS Interface

• E-CPOS Interface

•

Loopback and Null Interface

Layer 2 – LAN Switching

Command Reference

Covers the commands for configuring Layer 2 technologies and features in

a LAN switched network. This command reference includes:

• MAC Address Table

• Ethernet Link Aggregation

• Port Isolation

• MSTP

• BPDU Tunneling

• VLAN

• GVRP

• QinQ

• VLAN Termination

• VLAN Mapping

• LLDP

Layer 2 – WAN Access

Command Reference

Covers WAN access technologies. This command reference includes:

• ATM

• PPP

• L2TP

• HDLC

• Frame Relay

• Modem Management

Layer 3 – IP Services Command

Reference

Covers the commands for configuring and managing IP addressing

(including static and dynamic IPv4 and IPv6 address assignment), network

Summary of content (4 pages)

PAGE 1
About the HP HSR6800 Command References The HP HSR6800 command references are part of the HP HSR6800 Routers documentation set. They describe the commands and command syntax options available for the HP HSR6800 Routers. The HP HSR6800 documentation set includes 12 command references: Command reference Content Fundamentals Command Reference Covers the commands for logging in to and setting up an HSR6800 Router.
PAGE 2
performance optimization, ARP, and interoperation between IPv4 and IPv6.
PAGE 3
• IPv6 Multicast Routing and Forwarding • MLD • IPv6 PIM • IPv6 MBGP • PIM Snooping • Multicast VLAN MPLS Command Reference Describes the commands to configure MPLS and MPLS VPN, This command reference includes: • MPLS Basics • MPLS TE • MPLS L2VPN • VPLS • MPLS L3VPN ACL and QoS Command Reference Covers the commands for classifying traffic with ACLs, and allocating network resources and managing congestions with QoS technologies to improve network performance and network use efficiency.
PAGE 4
• URPF • FIPS High Availability Command Reference Covers high availability commands for managing failure detection and failover. Failure detection technologies focus on fault detection and isolation. Failover technologies focus on network recovery.