User's Manual

Drives
Hardware Guide 4–12
Removing an Optical Disc (No Power)
If power is unavailable:
1. Insert the end of a paper clip 1 into the manual eject recess in
the front bezel of the drive.
2. Press in gently on the paper clip until the media tray is
released, then pull out the tray 2 until it is fully extended.
3. Remove the disc 3 from the tray by gently pressing down on
the spindle while lifting the outer edges of the disc. Handle
the disc by the edges, not the flat surfaces. If the media tray is
not fully extended, tilt the disc as you remove it. To protect
the disc, place it in a protective case.
4. Close the media tray.
Your model might vary slightly from this illustration.
348383-001.book Page 12 Friday, September 12, 2003 10:50 AM