User's Manual

Laser safety
For products equipped with optical drives or fiber optic transceivers.
This product may be provided with an optical storage device (i.e., CD or DVD drive) and/or fiber optic
transceiver. These contain lasers and are classified as Class 1 Laser Products in accordance with the standard
IEC/EN 60825-1 and comply with its requirements.
Each laser product complies with US FDA Regulations of 21 CFR 1040.10 and 1040.11 or complies with those
regulations except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
WARNING! Use of controls or adjustments or performance of procedures other than those specified herein
or in the laser product’s installation guide may result in hazardous radiation exposure. To reduce the risk of
exposure to hazardous radiation:
●
Do not try to open the module enclosure. There are no user-serviceable components inside.
●
Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specified herein.
●
Allow only HP Authorized Service technicians to repair the unit.
Power supply and power cord set requirements
Power supply class I grounding requirements
For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the
system power cord into an AC outlet that provides a ground connection. Substitute cords may not provide
adequate fault protection. Only use the power cord supplied with this product or a Hewlett-Packard
authorized replacement.
Brazil notice
Este equipamento deve ser conectado obrigatoriamente em tomada de rede de energia elétrica que possua
aterramento (três pinos), conforme a norma nbr abnt 5410,visando a segurança dos usuários contra choques
elétricos.
Denmark
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
Finland
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway
Apparatet må tilkoples jordet stikkontakt.
Sweden
Apparaten skall anslutas till jordat uttag.
Power supply requirements
The power supplies on some products have external power switches. The voltage select switch feature on the
product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power supplies on
28 Chapter 4 Safety notices for desktops, thin clients and personal workstations