Operation Manual

2-4 ENWW
Setting up the printer
To set up the printer, complete the following steps.
Note For illustrated setup information, see the setup poster.
Step 1: Check the box contents
Unpack the printer and remove the packing tape and shipping foam.
Step 2: Install the printer trays
Install tray 2
1 Position the tray 2 base in the location where you want to place the
printer. The printer is designed to rest directly on top of the base.
2 Lift the printer and align it with the tray 2 base.
3 Set the printer on top of the tray 2 base.
4 Place the tray 2 cover on the end of the tray.
5 Align tray 2 with the opening in the tray 2 base, and then slide the
tray into the base until it snaps into place.
Install the output tray
1 Align the output tray with the slot above the tray 1 opening.
2 Slide the output tray firmly into the printer until it snaps into place.
Install tray 1
Slide tray 1 into the printer below the output tray until it snaps into place.