Operation Manual

5-8 ENWW
CFG IPX/SPX NO
YES
Selects whether you want to use the
IPX/SPX menu and set the IPX/SPX
protocol parameters.
In the IPX/SPX menu, you can specify
the Frame Type parameter used on your
network.
! The default is AUTO, which
automatically sets and limits the
Frame type to the one detected.
! For Ethernet cards, frame type
selections include
EN_8023,
EN_II, EN_8022, EN_SNAP.
! For Token Ring cards, frame type
selections include
TR_8022,
TR_SNAP.
In the IPX/SPX menu for Token Ring
cards, you can also specify NetWare
Source Routing parameters, which
include
SRC RT=AUTO (default), OFF,
SINGLE R, or ALL RT.
CFG TCP/IP NO
YES
Selects whether you want to use the
TCP/IP menu and set the TCP/IP
protocol parameters.
In the TCP/IP menu, you can specify
BOOTP=YES or DHCP=YES for TCP/IP
parameters to be automatically
configured by a BootP or DHCP server
when the printer is turned on.
If you specify
BOOTP=NO and
DHCP=NO, you can manually set the
following TCP/IP parameters from the
LCD control panel:
! Each byte of the IP address (IP)
! Subnet Mask (SM)
! Syslog Server (LG)
! Default Gateway (GW)
! Idle Timeout period (default is 270
seconds; 0 disables the timeout)
When setting IP numbers, press
VALUE
to increase the number by 1. Press
SELECT to make your selection.
Message Value Description