Owner manual

Agent information 31
Self Test Results
The Self Test Results section indicates various error-status depending on the Remote Insight model. The following is the
list of error-status fields:
• Busmaster I/O Reads
• Memory
• Internal Modem Firmware
• Internal Modem
• External Port
• Keyboard Interface
• Battery Interface
• NVRAM Interface
• NVRAM Write/Read/Verify
• Video SideCard
• PCMCIA
• NIC
• Mouse
• CPLD
• SRAM
• EEPROM
• I2C
• Boot Block
• Thread Initialization
• Rack Infrastructure
• Reset Integrated Lights-Out (iLO)
The Reset Remote Insight button is used to Reset the Remote Insight Board. Once the Remote Insight is reset, The
HP Insight Management Agents takes a minimum of two minutes to reconnect with the Remote Insight depending
upon the poll interval.
Operating System
File System Space Used
Select the File System Space Used entry from the Mass Storage list to display the name of each volume, the number of
megabytes used by that volume out of the total available, the number of megabytes unused by that volume, the total
number of megabytes available, and the percentage of total space used. If disk space thresholds are set for any of
the volumes, they are represented by arrows at the top of the disk space usage bar graph.
Disk Space Usage Bar Graph
The bar graph uses a color code to indicate disk space status. The bar is blue if the disk space usage is at or below
the warning and critical thresholds or if no thresholds have been set for the volume. The bar is yellow if the disk space
usage is above the warning threshold and below the critical threshold. The bar is red if the disk space usage is above
the critical threshold. The unused space on the volume is displayed in gray.
Disk Space Usage Thresholds
The disk space usage threshold values are displayed inside triangular shaped indicators above the disk space usage
bar graph. A yellow indicator is used for the warning threshold and a red indicator is used for the critical threshold. If
the indicator is gray, then a threshold has not been created for this volume, or the threshold has been disabled.
Resetting and Saving Thresholds
If you have security access to create, modify, or delete thresholds, two buttons display at the end of the page:
• Reset to Original Values
• Save Thresholds
If there is more than one volume, a Synchronize thresholds for all volumes checkbox displays. Select the checkbox to
set all critical thresholds to the highest critical threshold value, and to set all warning thresholds to the highest warning
threshold value. If you change one threshold, the same threshold on all of the other volumes automatically change to
the same value.