Owner's manual

Appendix A Specifications
227
Power Distribution Board Jumpers (T-Docking)
Jumper blocks exist on the Power Distribution Board (T-Docking) that allow you
to force a firmware update, flash bootblock write enable, and configure for 220
Volt brownout protection. To access these jumper blocks you need expose the T-
Docking Board by following the instructions in Chapter 8, “Server Management
Boards”.
J4D1
J4E2
J4E1
Figure A-24. T-Docking Board Jumper Locations
Jumper setting labeled:
Jumper
Function
J4E1 Force Firmware Update
J4E2 Flash Bootblock Enable
J4D1 220V Brownout Protection