Owner's manual

Chapter 4 Installing Mass Storage Devices

3. While grasping only the drive carrier handle, firmly push the assembly

into the bay until the drive docks with the backplane connector and the

carrier latch locks.

Figure 4-2 Hot Swapping a SCSI Drive

4. Replace the plastic bezel on the front of the server.

Installing Non-Hot Swap Drives

The HP Server supports a slimline IDE diskette drive for 1.44 MB and 120 MB

media and a DVD drive. Both drives are part of the standard configuration and

mount directly above the power bays on the front of the chassis. The drives are

mounted on removable trays that facilitate system assembly and service. The

server must be powered down to install these drives.

Installing the Floppy Disk Drive

The floppy disk drive is housed in a two-piece drive carrier assembly that rests on

the chassis surface. The assembly is accessible when the top cover is removed.

The following procedures describe how to remove and install the drive.