Setup and Install

Figure 1 mezzanine card removal
CAUTION:
To prevent damage to the server blade, apply pressure over
the mezzanine connector when installing the mezzanine card.
Do not apply pressure to the edges of the card.
To install the replacement component, reverse the removal procedure.
Verifying component status
After installing the new IO Accelerator mezzanine card, check the system
logs and fio-status utility to make sure the device was installed properly.
In addition, the fio-pci-check utility should show that it has 1000 MB/sec
of bandwidth available to each mezzanine card. If it only shows 500
MB/sec or less, you may not have seated the card properly. Remove
the card and re-install using the instructions above.
Returning the failed component
Follow instructions shipped with the replacement part.
Additional information
HP BladeSystem technical resources (white papers and support
documents): h
ttp://www.hp.com/go/bladesystem/documentation
HP BladeSystem components: http://h18004.www1.hp.com/products/
blades/components/c-class-components.html
HP support: http://www.hp.com/support
Page 2