Hardware Reference Guide HP rp5800

10. Rotate the drive cage to its upright position.
Figure 2-50 Rotating the Drive Cage Up
11. Connect the power cable (1) and data cable (2) to the rear of the optical drive.
NOTE: The power cable for the optical drive is a three-headed cable that is routed from the
system board to the primary hard drive, then to the secondary hard drive, then to the rear of the
optical drive.
Figure 2-51 Connecting the Power and Data Cables
12. Connect the SATA data cable to the black eSATA connector on the system board labeled
SATA2 unless an eSATA adapter is installed. If an eSATA adapter is installed, connect the
SATA data cable to the light blue SATA connector on the system board labeled SATA1.
NOTE: Refer to System Board Drive Connections on page 40 for an illustration of the system
board drive connectors.
ENWW Installing and Removing Drives 45