HP Point of Sale (POS) Peripherals Configuration Guide

Page 218 of 522
6.5.15 JPOS Drivers for the Receipt Printer Drivers – Ethernet
If you are using the Ethernet version of the receipt printer, the entry in the CONFIG.XML must
be edited to reflect the Ethernet port and IP Address to which the printer is attached. The
CONFIG.XML from HP is located in the “..\Receipt Printer JPOS\JPOS\jpos\res” folder; the
location will most likely be different location for you point of sale application. Please contact
your administrator or POS application provider to assist on making changes to the
configuration setting.
1. Plug the printer into the network and have power to the printer.
2. Run a diagnostic printout and obtain the printer IP address from the printout.
Steps to obtain a diagnostics printout.
a) Be sure paper is in the printer (1).
b) Open the receipt cover (2).
c) Press and hold the paper feed button (3).
d) Close the receipt cover (2).
Note: The default IP address is 192.0.0.192. If this address appears on the printout,
the printer has not obtained an IP address.