HP rp5800 Retail System - Maintenance & Service Guide

Bezel Blank
On some models, there is a bezel blank covering the optical drive bay that must be removed before
installing a drive. To remove a bezel blank:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 42).
2. Remove the access panel (
Access Panel on page 43).
3. Remove the front bezel (
Front Bezel on page 44).
4. Push outward on the two retaining tabs that hold the bezel blank in place (1) then pull the blank
inward to remove it (2).
Figure 7-7 Removing a Bezel Blank
48 Chapter 7 Removal and Replacement Procedures