Programming Reference Guide

Chapter 3

Configuration Using Barcodes

This and following sections provide programming barcodes to configure your scanner by

changing the default settings. For details about additional methods of programming, see

"Co

nfiguration Methods" on page 3.

Configuration Parameters

Once the scanner is set up, you can change the default parameters to meet your application

needs. Refer to "Standard Defaults" starting on page 255 for initial configuration in order to

set the default values and select the interface

for your application.

Interface Configuration:

• "USB-Com Interface" on page 15

Parameters common to all interface applications:

• "Data Format" on page 31 gives options to control the messages sent to the Host sys-

tem.

• "Reading Parameters" on page 45 control various operating modes and indicators sta-

tus functioning.

Symbology-specific parameters:

• "1D Symbologies" on page 65 provides configuration of a personalized mix of 1D

codes, code families and their options.

• "2D Symbologies" on page 159 provides configuration of a personalized mix of 2D

codes, code families and their options.

You must first enable your scanner to read barcodes in order to use this

section. If you have not done this, go to

Setup, starting on page 5

and

complete the appropriate procedure.

You must first enable your scanner to read barcodes in order to use this

section. If you have not done this, go to

Setup, starting on page 5

and

complete the appropriate procedure.