Programming Reference Guide

Enter/Exit Programming Mode
202 HP Wireless Barcode Scanner
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
Link Timeout
This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See page 212 for more information on setting this feature.
This feature only applies if "Source Radio Address Transmission" on
page 201 is enabled.
Set Source Radio Address Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
l
eft followed by the digits from the Alphanumeric char-
acters in
Appendix D. Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
b
arcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then
start again at the beginning.
CANCEL
$CBTAD
~
DEFAULT
00 = No Delimiter Character
Set Link Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D. Keypad
representing your desired character(s). End by
scanning
the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abor
t and not save the entry string. You can then
start again at the beginning.
CANCEL
$CBTLT
~
DEFAULT
02 Link Timeout value is 2 seconds