Programming Reference Guide

Enter/Exit Programming Mode
12 HP Wireless Barcode Scanner
To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-
gramming page, when applicable.
2. Scan the barcode to set the desired programmin
g feature. You may need to cover
unused barcodes on the page, and possibly the facing page, to ensure that the scanner
reads only the barcode you intend to scan.
3. If additional input parameters are needed, go t
o Appendix D, Keypad, and scan the
appropriate characters from the keypad.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING barcode to exit Programming Mode.
For more detailed descriptions,
programming information and examples for setting selected
configuration items, see References, starting on page 209.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL barcode to
abor
t and not save the entry string. You can then start again at the begin-
ning.
The scanner can be set to decode barcode labels only when they are close
to the
center of the aiming pattern. This allows the handheld to accurately
target labels when they are placed close together, such as on a pick sheet.
See
Pick Mode, starting on page 56.