Programming Reference Guide

References
240 HP Wireless Barcode Scanner
Table 45. BT Pin Code Setting Examples
Motion Features
Motionless Timeout
This setting specifies the amount of time that the scanner takes to assume that it is in a
motionless condition. The range for this setting is from 500 msec to 25.5 seconds, in 100
millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0.5 = 0005 = 00, 5
= 0
50, 20 = 200, etc.
3. Go to page 208 and scan the ENTER/EXIT PROGRAMMING MODE barcode to
enter Programming Mode.
4. Scan the barcode: SELECT MOTIONLESS TIMEOUT SETTING.
5. Scan the appropriate three digits from the keypad in Appendix D, Keypad representing
the duration which was determine
d in the steps above. You will hear a two-beep indi-
cation after the last character.
6. Scan the ENTER/EXIT PROGRAMMING MODE barcod
e to exit Programming
Mode.
This completes the procedure. See Table 46 for examples of how to set this feature.
Table 46. Motionless Timeout Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting D254 STOR12345678135M
2
Convert the characters
to
hexadecimal
44 32 35 34
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35
4D
3 Scan ENTER/EXIT P
ROGRAMMING MODE
4 Scan SET BT PIN CODE
5
Scan 8 or 32
Alphanum
eric
Characters From
Appendix D, Keypad
44323534 53544F5231323334353637383133354D
6 Scan ENTER/EXIT P
ROGRAMMING MODE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.