Programming Reference Guide

Enter/Exit Programming Mode
22 HP Wireless Barcode Scanner
Disable Character
Specifies the value of the host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 215 for more information on setting this feature.
Enable Character
Specifies the value of the host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 216 in “References” for more information on setting this feature.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of this character.
Select Disable Character Setting
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of this character.
Select Enable Character Setting
$CR2DC
DEFAULT
0x44 = Disable Character is ‘D’
$CR2EC
DEFAULT
0x45 = Enable Character is ‘E’