Programming Reference Guide

Enter/Exit Programming Mode
28 HP Wireless Barcode Scanner
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable
range for this feature is from 0 to 99 seconds.
See page 218 in “References” for detailed information a
nd examples for setting this feature.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry s
tring. You can then start
again at the beginning.
CANCEL
$CKBID
~
DEFAULT
00 = No Intercode Delay