Programming Reference Guide

Enter/Exit Programming Mode Global Prefix/Suffix
32 HP Wireless Barcode Scanner
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value
from 00 to FF. The characters may be added as a prefix (in a position before the barcode
data, also called a header) and/or as a suffix (in a position following the barcode data, also
called a footer). See page 221 for more detailed instructions on set
ting this feature.
To configure this feature, scan the ENTER/EXIT PR
OGRAMMING MODE barcode above
to place the unit in Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,”
barcode followed by the digits (in hex) from the Alphanumeric characters in Appendix D,
Keypad representing your desired character(s). If
less than the expected string of 20
characters are selected, scan the ENTER/EXIT barcode to
terminate the string. Exit
programming mode by scanning the ENTER/EXIT barcode again.
Set Global Prefix
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
$CLFPR
$CLFSU
~
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)