Programming Reference Guide

Enter/Exit Programming Mode

52 HP Wireless Barcode Scanner

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a

good read. The good read LED on time can be set within a range of 100 milliseconds to

25,500 milliseconds (0.1 to 25.5 seconds) in 100ms increments. A setting of 00 keeps the

LED on until the next trigger pull.

See page 229 in “References” for detailed instructions and

examples for setting this feature.

Good Read LED Duration Setting =

Keep LED on until next trigger pull

Select Good Read LED Duration Setting

To configure this feature, s

can the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

eft followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

arcode again.

Make a mistake? Scan the CANCEL barcode to abort and

not

save the entry string. You can then start again at the

beginning.

CANCEL

$CLAGL00(CR)

$CLAGL

DEFAULT

003 = Good Read LED

stays on for 300 ms.

Indicators are dimmed during sleep.