Programming Reference Guide

Enter/Exit Programming Mode
Programming Reference Guide 55
Stand Operation
Specifies the behavior of the scanner when stationary in a stand. There are two conditions
which cause the scanner to switch to Stand Mode:
1. The scanner is configured to switch to
Stand Mode when stationary.
2. The scanner is placed into the cradle of the base station.
Below are further options concerning Stand Operation.
Ignore Autorecognition. Disables mode switching when the scanner is placed in a stand.
Switch to Stand Mode. Automatically switches the scanner to Stand Mode when the scanner
is placed in the stand.
Switch to Flashing. Automatically switches the scanner to Flash Mode when the scanner is
placed in the stand.
Switch to Always On. Automatically switches the scanner to Always On mode when the
scanner is placed in the stand
.
Do Not Change Mode
Change to Stand Mode
Change to Always On
Change to Flashing
$CSMSD00(
CR)
$CSMSD01(
CR)
DEFAULT
$CSMSD02(CR)
$CSMSD03(CR)