Programming Reference Guide

Enter/Exit Programming Mode

Stand Mode Illumination Off Time

Specifies the amount of time scanner illumination stays off after pulling the trigger when in

Stand Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16

seconds). See page 231 in “References” for a description of this feature.

Scanning Active Time

This setting specifies the amount of time that the scanner stays in scan ON state once the

state is entered. The range for this setting is from 1 to 255 seconds in 1-second increments.

See page 232 in “References” for further description of this feature.

Select Stand Mode Time Setting

To configure this feature, sc

an the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

eft followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

rcode again.

$CSNTM

DEFAULT

04 = 2 Seconds

Scanning Active Time = 3 seconds

Scanning Active Time = 5 seconds

Scanning Active Time = 8 seconds

$CSNET03(CR)

$CSNET05(CR)

DEFAULT

$CSNET08(CR)