Programming Reference Guide

Enter/Exit Programming Mode
60 HP Wireless Barcode Scanner
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in
trigger single mode.The range for this setting is from 1 to 255 seconds in 1-second
increments. See page 233 in “References” for a description of this feature.
DEFAULT
06 = Flash is OFF for 600ms
Aiming Pointer = Disable
Aiming Pointer = Enable
$CTAAP00(CR)
$CTAAP01(CR)
DEFAULT
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE
barcode above, then the barcode at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired char-
acter(s). End by scanning the ENTER/EXIT bar
code.
Make a mistake? Scan the CANCEL barcode to abort and
not
save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
LSTM00
LSTM
~