HP SureStore AutoBackup Administrator's Guide - Not Orderable

4002
No
Cleaning
tape
I
The system cannot boot off a
cleaning tape.
8016
No EODmark
E F
The drive is trying to read what
appears to be a blank cartridge (one
with no DDS-format End of Data
pattern). This is probably a result of
power failure while writing.
4003
No tape in
slot 1
I
There is no tape in slot 1. HP OBDR
requires a tape in slot 1 from which
it can boot.
8021
Non-MRS
Tape
E F
A WRITE, WRITE FILEMARK or
ERASE command has been
attempted on a non-Media
Recognition System cartridge.
Action: Remove the cartridge and
replace with a Media Recognition
System cartridge. See Choosing
Cartridges.
4000
OBDR Mode
I/S F
The drive has switched to HP
One-Button Disaster Recovery
mode and is restoring the operating
system.
1017
Partition
S
The drive is switching to the other
partition on a two-partition tape.
8017
Partition
1 too
large
E O
A command to format the tape has
failed because the requested size for
partition 1 is too large.
Action: Try again with a smaller
partition 1 or, if possible, a longer
tape.
2007
Press
Eject
I Press the EJECT button.
1009
Read
S
The drive is reading data from the
tape.
8012
Read Fail
E F
A read has failed. The host should
reposition and try again.
Read Only
S
Loaded cartridge is write-protected.
See the “Ready xxm” message.
Front Panel Lights, Autoloader
file:///D|/ADMIN_~1/eng/tape/lights_a.htm (13 of 17) [5/3/2000 3:33:43 PM]