HP SureStore AutoBackup Administrator's Guide - Not Orderable

Problems with Your AutoBackup
Appliance
When does the problem occur?
When Installing The Appliance
During Power On
During the Boot Up Sequence
In Operation
Installing the Appliance
The setup and configuration of the appliance before its operational use.
Follow the instructions on the Installation poster. The steps are as follows:
Plug the appliance into the network
Power on the appliance
Run the AutoBackup Installation utility on a networked PC
Configure the appliance's settings
If this is not the case, do you see one of the following symptoms?
The appliance cannot be found on the network.
Back to top
Power On
The state of the appliance when it has been plugged in and before it begins its bootup
procedures
When the appliance is plugged in but not switched on, the LCD is unlit and the light
bar is solid orange. When the appliance is switched on, the light bar should turn solid
Troubleshooting, Appliance
file:///D|/ADMIN_~1/eng/trouble/trouble1.htm (1 of 11) [5/3/2000 3:34:19 PM]