User's Manual

2- 4 Hardware Installation Procedures
Verifying Successful Installation
After the hp bt1300 is attached to the printer and powered ON, it will perform a brief startup sequence:
1. The tri-colored LED (amber) and the blue LED will blink three times simultaneously.
2. The tri-colored LED will alternately blink amber and green twice. The blue LED will not light.
3. The tri-colored LED will illuminate green continuously, and the blue LED will blink continuously,
indicating a ready state. After Bluetooth connectivity has been established, the blue LED will
illuminate continuously.
NOTE: If the tri-colored LED does not illuminate green continuously after the device has finished its startup
sequence, then there may be an error. Refer to Chapter 5 – Troubleshooting in this user’s guide for help.
Verifying the Connection to the Printer
To verify the connection, make sure that both the hp bt1300 and the printer are powered on and ready.
Then print a test page by momentarily pressing the test button on the hp bt1300 for about one second.
If the test page prints successfully, then the hp bt1300 is ready to print, providing that the client
computer and sending device are ready to print.
If the test page does not print, first check to make sure that the hp bt1300 is securely connected to the
printer. Also, make sure that the printer is operating properly and has a sufficient supply of paper and
toner or ink. Switch the hp bt1300 off and then on again, and then try printing the self-test page again
by pressing the test button for about one second. If you cannot print a test page, refer to Chapter 5 –
Troubleshooting in this user’s guide.