HP Jetdirect Print Server 620n - Setup Guide

Troubleshooting Tools 23
ENWW
Note The HP Jetdirect 10/100Base-TX print server may
require up to 10 seconds to establish a connection
on the network.
Try the following troubleshooting procedures:
O Verify cabling connections.
O Configure the print server’s 10/100TX link setting directly (for
example, using the EIO menu on the printer’s control panel).
Verify that the configuration of the connecting network device
(such as a network switch) matches. For example, if you set the
print server for 100Base-TX Full-Duplex operation, the port on
the network switch must also be set to 100Base-TX Full-Duplex
operation. Power-cycle the printer to reinitialize the setting.
O On the Jetdirect Configuration Page, compare your configuration
for the following parameters:
Parameter Expected Messages for 10/100TX Cards
PORT SELECT: RJ-45
PORT CONFIG: 100TX HALF, 100TX FULL, 10BASE-T HALF,
10BASE-T FULL
AUTONEGOTIATION: ON (Autonegotiation is enabled), or
OFF (Autonegotiation is disabled, 10/100TX
configuration has been manually set)