HP Jetdirect 2700w USB Print Server - Setup Guide
Table Of Contents
- Introduction
- Specifications
- Supported HP software solutions
- Troubleshooting
- Regulatory statements
- Regulatory model identification numbers
- European Union & United Kingdom Regulatory Notice
- FCC regulations
- Canada - Industry Canada ICES-003 Compliance Statement
- Wireless statements
- FCC compliance statement—United States
- Notice to users in Argentina
- Brazil: (Português)
- Canadian statements
- Exposure to Radio Frequency Radiation (Canada)
- China CMIIT Wireless Statement
- European Regulatory Notice
- Notice to users in Indonesia
- Notice to users in Korea
- Mexico statement
- Notice to users in Singapore
- Notice to users in South Africa
- Notice to users in the Ukraine
- RFID/NFC Statement
- Environmental product stewardship program
- Service and support
- Glossary for Network printing terms and concepts
- Glossary for Wireless LAN terms and concepts
- Index
FCC regulations
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
NOTE: Any changes or modications to the printer that are not expressly approved by HP could void the user’s
authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules.
Canada - Industry Canada ICES-003 Compliance Statement
CAN ICES-003(B)/NMB-003(B)
Wireless statements
FCC compliance statement—United States
Exposure to radio frequency radiation
CAUTION: The radiated output power of this device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact during normal
operation is minimized.
In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna shall not be less than 20 cm (8 in) during normal operation.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
CAUTION: Based on Section 15.21 of the FCC rules, changes of modications to the operation of this product
without the express approval by HP may invalidate its authorized use.
Notice to users in Argentina
FCC regulations 21